Re: fatal:Value too large for defined data type

From: Dennis Shea <shea_at_nyahnyahspammersnyahnyah>
Date: Thu, 12 Mar 2009 18:43:18 -0600

Were you accessing this same file under 5.0.0?

Are any of the variables on the file larger than 2GB in size?

Teresa Valkonen wrote:
> Hello,
>
> I tried to install NCL 5.1.0 and I thought I did it successfully since I
> can run test scripts without problems. But now I have a major problem. I
> am not able to read in my data which is output from WRF model.
>
> I try to read the file like this:
> a = addfile("../cases/dec07/wrfout_d03_2007-12-29_00:00:00.nc","r")
>
> And I keep getting this error message:
> fatal:Value too large for defined data type
> fatal:Could not open (../cases/dec07/wrfout_d03_2007-12-29_00:00:00)
>
> The file is about 12 Gb big but I never had any problems with the older
> version of NCL. Would you know what the problem is? I have a i686
> GNU/Linux.
>
> Best regards
> Teresa Valkonen, doctoral student
> University of Helsinki, Finland
>
> _______________________________________________
> ncl-install mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-install
_______________________________________________
ncl-install mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-install
Received on Thu Mar 12 2009 - 18:43:18 MDT

This archive was generated by hypermail 2.2.0 : Wed Mar 18 2009 - 14:50:42 MDT