Re: ncl cannot be run under cygwin in 64-bit windows 7

Xuguang,

The precompiled Cygwin/NCL binary is a 32-bit binary. Unfortunately I
don't have a 64-bit Windows machine to test it on. I think it should
work, however.

I think the problem may be with your version of Cygwin. Other users
have reported to me that they had to upgrade Cygwin before they could
run NCL.

The Cygwin "setup.exe" I used was version 2.697. If your Cygwin was
installed with an older version of "setup.exe", then you probably need
to upgrade it.

See the notes at:

http://www.ncl.ucar.edu/Download/cygwin.shtml#InstallCygwinX

--Mary

On May 2, 2010, at 12:52 PM, Xuguang Sun wrote:

> Dear All,
>
> I downloaded the cygwin version of NCL 5.2.0 binary, and
> successfully uncompressed it under cygwin. I run ncl after I did
> some environmental settings, however, it didn't work, I meant there
> were nothing coming out, no error or warning messages, just went
> back to the command prompt, for example,
>
>> ncl <returen>
>
>>
>
> I don't know why it doesn't work, my windows system is 64-bit
> windows 7, perhaps ncl is compiled on 32-bit platform and cannot be
> run on 64-bit platform. Could you please give me some suggestions?
> Thanks.
>
> Best regards,
>
> Xuguang SUN
>
>
>
>
>
> _______________________________________________
> ncl-install mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-install

_______________________________________________
ncl-install mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-install
Received on Sun May 2 14:46:01 2010