Re: NCL & PGI

Mary,

Thanks. The file is attached.

--
Mack J. Jenkins, II
404-385-1591
mack.jenkins@eas.gatech.edu
System Support Engineer II
Earth & Atmospheric Sciences
----- Original Message -----
From: "Mary Haley" <haley@ucar.edu>
To: "Mack Jenkins" <mack.jenkins@eas.gatech.edu>
Cc: "Ted Mansell" <ted.mansell@noaa.gov>, ncl-install@ucar.edu
Sent: Thursday, January 12, 2012 10:12:21 PM
Subject: Re: NCL & PGI
Hi Mack,
Can you email me the output file from the "make Everything"? I should be able to tell right away why the "ncl" executable didn't build.
It's likely that one of the external software packages that NCL depends on was either not built, or built with the wrong options.
--Mary
On Jan 12, 2012, at 1:02 PM, Jenkins, Mack wrote:
> Thanks to Ted and Mary for the assit.  This is my encounter with NCL, so I hope I do not ask and stupid questions.  
> 
> I copied the contents of LINUX.64.PGI to the LINU file in the config directory, and all seemed to compile.  The researchers using this system told me that there is no ncl binary.  I looked in the 'bin' directory, and there are a lot of files, but no ncl.  Were there any additional flags that I needed to give it?  I read through the INSTALL.txt file, but don't remember seeing anything that stood out as being extra important.
> 
> --
> Mack J. Jenkins, II
> 404-385-1591
> mack.jenkins@eas.gatech.edu
> System Support Engineer II
> Earth & Atmospheric Sciences
> 
> ----- Original Message -----
> From: "Ted Mansell" <ted.mansell@noaa.gov>
> To: "Mack Jenkins" <mack.jenkins@eas.gatech.edu>
> Cc: ncl-install@ucar.edu
> Sent: Monday, January 9, 2012 11:33:14 AM
> Subject: Re: NCL & PGI
> 
> I just used LINUX.64.PGI, so you could try copying that to LINUX in the 'config' directory.
> 
> Are you having a specific error, or just not sure where to start?
> 
> Good luck,
> 
> -- Ted
> 
> On Jan 9, 2012, at 8:30 AM, Jenkins, Mack wrote:
> 
>> I have searched and I can not find a good point of reference, so I hope that someone here might be able to assist.  I am trying to install NCL, but use the pgf90 and pgcc.  I've seen other people on google searches ask this question, but I have yet to see an answer.  Can someone point me to a good reference, or, give me the correct ./Configure flag layout if you have it handy.
>> 
>> Thanks in advance.
>> 
>> --
>> Mack J. Jenkins, II
>> 404-385-1591
>> mack.jenkins@eas.gatech.edu
>> System Support Engineer II
>> Earth & Atmospheric Sciences
>> 
>> _______________________________________________
>> ncl-install mailing list
>> List instructions, subscriber options, unsubscribe:
>> http://mailman.ucar.edu/mailman/listinfo/ncl-install
> 
> _______________________________________________
> ncl-install mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-install