Hi John,
Yes, you can certainly try removing the references to that file to see if it works. Once you do that, you will need to remake the
Makefile in that directory:
cd $NCARG/ni/src/ncl
[edit the yMakefile and remove the references]
[save the file]
make me
make all install
If this produces an executable called "ncl", then you are good to go, and you can finish the full installation by typing:
cd $NCARG
make all install >&! make-output.2
I'm using $NCARG to represent the top level of the NCL source tree.
If this doesn't work, then Dave might be able to give you a fixed file.
Good luck,
--Mary
On Jan 3, 2013, at 2:56 PM, John Donners wrote:
> Hello Mary,
>
> thank you very much. Indeed I got a fixed yMakefile from David Brown
> that would fix another problem in 6.1.0 (see an earlier email on ncl-talk).
> I assume that I can just remove the two references to NclExitCode.h in
> that yMakefile?
>
> Cheers,
> John
> ________________________________________
> From: Mary Haley [haley@ucar.edu]
> Sent: 03 January 2013 22:32
> To: John Donners
> Cc: ncl-install@ucar.edu
> Subject: Re: missing include file ni/src/ncl/NclExitCode.h
>
> Hi John,
>
> This is odd, because I don't think this file was added until after 6.1.0 was released.
>
> Did you download the 6.1.0 source code from the ESG website?
>
> I just did this myself, and didn't see any reference to this file in the ni/src/ncl directory.
> Normally you would see the reference in the 'yMakefile' in that directory.
>
> --Mary
>
> On Jan 3, 2013, at 1:17 AM, John Donners wrote:
>
>> Dear developers,
>>
>> I've been compiling NCL on an IBM Power6 system with linux and I noticed
>> the following problem:
>>
>> ncl610@p6012:~/ncl_ncarg-6.1.0> make includes
>> ...
>> Making includes in ./ni/src/ncl
>> make[3]: Entering directory `/gpfs/h05/ncl610/ncl_ncarg-6.1.0/ni/src/ncl'
>> make[3]: *** No rule to make target `NclExitCode.h', needed by `includes'. Stop.
>> make[3]: Leaving directory `/gpfs/h05/ncl610/ncl_ncarg-6.1.0/ni/src/ncl'
>> Making includes in ./ni/src/mkwrap
>> ...
>>
>> I can't find this file anywhere, or how it would be generated otherwise. Can you
>> help me?
>>
>> With regards,
>> John
>> --
>> John Donners
>> Consultant
>> OSD
>> SURFsara
>>
>> _______________________________________________
>> ncl-install mailing list
>> List instructions, subscriber options, unsubscribe:
>> http://mailman.ucar.edu/mailman/listinfo/ncl-install
>
_______________________________________________
ncl-install mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-install
Received on Fri Jan 4 09:03:17 2013
This archive was generated by hypermail 2.1.8 : Mon Jan 14 2013 - 14:32:39 MST