Re: warnings

From: MICHAEL NOTARO <mnotaro_at_nyahnyahspammersnyahnyah>
Date: Sun, 19 Apr 2009 17:14:42 -0500

Agnes,
You should probably set the min value as 0 and the max
as 70 (you have them reversed).
Michael

----- Original Message -----
From: Agnes Lim Huei Ni <alim_at_ssec.wisc.edu>
Date: Sunday, April 19, 2009 4:11 pm
Subject: warnings
To: ncl-talk_at_ucar.edu

> Hi
>
> I had the following warnings but not sure why since I had used it
> many
> times.
> warning:ContourPlotSetValues: Invalid level values set: using
> AUTOMATICLEVELS mode
> warning:ContourPlotSetValues: Data values out of range of levels set
> by
> MANUALLEVELS mode
>
> the code used were
> res_at_cnLevelSelectionMode = "ManualLevels" ; set manual contour levels
> res_at_cnMinLevelValF = 70 ; set min contour level
> res_at_cnMaxLevelValF = 0 ; set max contour level
> res_at_cnLevelSpacingF = 5 ; set contour spacing
>
> Thanks
> Agnes
>
> _______________________________________________
> ncl-talk mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-talk
_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk
Received on Sun Apr 19 2009 - 16:14:42 MDT

This archive was generated by hypermail 2.2.0 : Mon Apr 20 2009 - 09:36:23 MDT