the nice thing about netCDF is reading it.
The creation of netCDF can be tedious. "Somebody"
must create all the information.
[1]
You must be much more specific than this.
How did you create the binary file? fortran sequential/direct?
C stream binary? NigEndian or LittleEndian? etc
[2]
You could read the binary file directly in ncl
fbinrecread/fbinrecread/cbinread/... and use the
directly.
[3]
Two trivial binary to netCDF examples are at
http://www.ncl.ucar.edu/Applications/r-binary.shtml
Good luck
On 11/04/2010 10:00 AM, Thomas Schwitalla wrote:
> Hello,
>
> we are running WRF on a rotated lat-lon grid. Now I interpolated
> observations to a gridded field with the same x and y dimensions as the
> WRF grid.
> My question is: How can I convert this binary into netcdf to plot
> differences directly using NCL?
>
> Thanks a lot,
> Thomas
>
-- ====================================================== Dennis J. Shea tel: 303-497-1361 | P.O. Box 3000 fax: 303-497-1333 | Climate Analysis Section | Climate & Global Dynamics Div. | National Center for Atmospheric Research | Boulder, CO 80307 | USA email: shea 'at' ucar.edu | ====================================================== _______________________________________________ ncl-talk mailing list List instructions, subscriber options, unsubscribe: http://mailman.ucar.edu/mailman/listinfo/ncl-talkReceived on Thu Nov 4 10:59:28 2010
This archive was generated by hypermail 2.1.8 : Mon Nov 08 2010 - 08:08:50 MST