Dear all,
OK, I resolved the issue. Switching x and y did just fine. Thanks...
Regards,
Ekin
On Wed, Jan 2, 2013 at 2:48 PM, Ekin Akoglu <ekin@ims.metu.edu.tr> wrote:
> Dear all,
>
> I am using the same data set to produce contour plots with MATLAB and NCL.
> The resulting plots show significant differences. I used "natgrid" for
> gridding data in NCL, which uses natural neighbor interpolation. MATLAB
> plot was also produced with the very same natural neighbor interpolation
> method. However, somehow, there are significant differences which I could
> not understand why. I would be glad if you have any suggestions. The two
> plots and the NCL code are attached to this e-mail.
>
> Regards,
>
> --
> Ekin Akoglu
>
> Institute of Marine Sciences
> Middle East Technical University
> P.O. Box 28, 33731
> Erdemli, Mersin
> Turkey
>
> Web: www.ims.metu.edu.tr
> Email: ekin@ims.metu.edu.tr
> Phone: +90 324 521 34 34
> GSM: +90 506 554 03 90
>
-- Ekin Akoglu Institute of Marine Sciences Middle East Technical University P.O. Box 28, 33731 Erdemli, Mersin Turkey Web: www.ims.metu.edu.tr Email: ekin@ims.metu.edu.tr Phone: +90 324 521 34 34 GSM: +90 506 554 03 90
_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk
Received on Wed Jan 2 07:31:44 2013
This archive was generated by hypermail 2.1.8 : Fri Jan 04 2013 - 15:34:10 MST