Hi Alice,
I am cc'ing this to wrfhelp@ucar.edu.
'wrfhelp' wrote the code.
===
Please post questions to ncl-talk@ucar.edu and not to ncladmin@ucar.edu
THX
D
On 11/17/2010 04:33 PM, Alice Katharine Du Vivier wrote:
> Hi,
>
> I am running NCL version 5.1.1 on a linux system. I have WRF ARW output
> and am trying to rotate the 10m winds to earth coordinates. I have been
> using the function "uvmet10" in the script and I have attached the
> section in question. When I run the script I get the following error
> messages:
>
> "(0) Warning: Input field was not unstaggered
> (0) Warning: Input field was not unstaggered"
>
> I have looked at the NCL source code for the "uvmet10" function (in
> "WRFUserARW.ncl") and there is a procedure to unstagger the the U10 and
> V10 variables that correspond to the 10m u and v winds. However,
> according to the WRF-ARW V3 User's Guide the U10 and V10 variables are
> not staggered output fields.
>
> When I run my script with these unstaggered variables the winds do
> appear to change, but I am not sure that the procedure is running
> properly still. Could you please let me know if this is an error with
> the 10m wind rotation code or if it is correct please let me know if I
> am not calling the code properly in my script.
>
> Thanks so much for the help.
> Cheers,
> Alice
>
>
-- ====================================================== Dennis J. Shea tel: 303-497-1361 | P.O. Box 3000 fax: 303-497-1333 | Climate Analysis Section | Climate & Global Dynamics Div. | National Center for Atmospheric Research | Boulder, CO 80307 | USA email: shea 'at' ucar.edu | ====================================================== _______________________________________________ ncl-talk mailing list List instructions, subscriber options, unsubscribe: http://mailman.ucar.edu/mailman/listinfo/ncl-talkReceived on Wed Nov 17 16:41:14 2010
This archive was generated by hypermail 2.1.8 : Fri Nov 19 2010 - 11:51:06 MST