Thanks Dennis. But I've got another questions. I find it difficult to locate
the position of the trough. Does anyone have some codes for performing this
or are there any suggestions of how I can achieve this? Any help and
suggestion would be greatly appreciated.
Shinn
2011/1/29 Dennis Shea <shea@ucar.edu>
> If you specify the locations:
>
> possibly
> http://www.ncl.ucar.edu/Document/Functions/Built-in/rcm2points.shtml
>
> or, for rectilinear grids
>
> http://www.ncl.ucar.edu/Document/Functions/Contributed/linint2_points_Wrap.shtml
>
> Then use gsn_polyline
>
> Good luck
>
>
> On 1/29/11 5:21 AM, shinn wong wrote:
>
>> Dear ncl users,
>> Does anyone have some simple ways for drawing the trough/ridge axis?
>> Many thanks.
>> Regards,
>> Shinn
>> _______________________________________________
>> ncl-talk mailing list
>> List instructions, subscriber options, unsubscribe:
>> http://mailman.ucar.edu/mailman/listinfo/ncl-talk
>>
>
_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk
Received on Wed Feb 2 00:04:51 2011
This archive was generated by hypermail 2.1.8 : Fri Feb 04 2011 - 09:26:53 MST