hi all -
I am making a contour plot and I want the min and max values to be 0 and 42.
If using *ManualLevels* as selection mode and setting those values for min
and max, I end up with a plot with limits *-2* and *44 *(instead of 0 and
42). Why does this happen? Can I make the cnMaxLevelValF and cnMinLevelValF
correspond to the exact minimum and max values?
Therefore, to fix that I am having to set the following resources:
res@cnLevelSelectionMode = "ManualLevels"
res@cnMinLevelValF = 2.
res@cnMaxLevelValF = 40.
res@cnLevelSpacingF = 2.
However, it's not showing the first and last labels (namely 0 and 42) which
is what I want in the first place. Any hints?!
Thanks,
-- *Paula Doubrawa Moreira** *Graduate Student - Research Assistant International Arctic Research Center University of Alaska Fairbanks
_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk
This archive was generated by hypermail 2.1.8 : Tue Jul 12 2011 - 15:03:53 MDT