>
> I am currently engaged in creating a rather large simulation, the
> dimensions of the grid are 551x551x61.
>
> When I try and create a plot, I get the following message:
>
> fatal:ContourPlotDraw: Workspace reallocation would exceed maximum size
> 16777216
> fatal:ContourPlotDraw: draw error
> fatal:ContourPlotDraw: draw error
> fatal:PlotManagerDraw: error in plot draw
> fatal:_NhlPlotManagerDraw: Draw error
>
>
> Any ideas?
>
> Thanks.
>
> Lou Wicker
>
Hi Lou,
You need to increase your workspace size, so try adding the following
lines to your script, right after you open a workstation:
setvalues NhlGetWorkspaceObjectId()
"wsMaximumSize" : 33554432
end setvalues
Another point to note, and this is from a previous posting from
Dennis Shea:
Depending on your contour interval, this may not do it. Also if
the workspace is blowing up it's likely that this plot will take
a LONG time to create.
Switching to raster contouring mode will fix all this.
To switch to raster contouring, set the resource "cnRasterModeOn" to
True.
--Mary
_______________________________________________
ncl-talk mailing list
ncl-talk@ucar.edu
http://mailman.ucar.edu/mailman/listinfo/ncl-talk
This archive was generated by hypermail 2b29 : Wed Jul 31 2002 - 13:18:57 MDT