Dear Mary,
Thank you. ' and ` problem is solved.
Next stage is Configure.
I want only ncl installation.
Among very many options of 10 item more, what do I need to set ?
Thank you, every time.
--Kbin
------ Original Message ------
Date: Wednesday, Dec 29, 2010 12:07:17 AM
From: Mary Haley <haley@ucar.edu>
To: Kbin Yun <rudqlsfjq@nate.com>
Cc: <ncl-install@ucar.edu>
Subject: Re: [ncl-install] I have Error message when installation version ncl-src-5.2.1
Kbin,I don't see any output from "ymake" commands in the image you attached. Mostly I see commands related to looking for and installing libgfortran.Again, with the commands you are typing below, you are using the wrong tick character. There are two characters that look like a tick. You need to use the one that has a slight slant to it with the top part of the tick starting on the left, and the bottom part ending on the right. Usually this tick is on the same key as the "~" character.Please *carefully* note the difference:'pwd' - INCORRECT`pwd` - CORRECT--Mary
On Dec 26, 2010, at 5:55 PM, Kbin Yun wrote:
Dear expert,
I attempted your instruction.
../ymake -config 'pwd'
./ymake -config 'and'
./ymake -config "pwd"
The result was attached for an image file .--Kbin
------ Original Message ------<result.jpg>_______________________________________________
Date: Friday, Dec 24, 2010 12:47:49 AM
From: Mary Haley <haley@ucar.edu>
To: Kbin Yun <rudqlsfjq@nate.com>
Cc: <ncl-install@ucar.edu>
Subject: Re: [ncl-install] I have Error message when installation version ncl-src-5.2.1
Dear Kbin,I think you might have a typo. You need to use the back tick around the "pwd":./ymake -config `pwd`Note the difference between ` and '. You need to use `.--MaryOn Dec 22, 2010, at 11:35 PM, Kbin Yun wrote:
To ncl-install expert
Hello~
gcc version is 3.4.5.
so, I can't installed another version. The last way is sorce code.
The order is
1. gunzip ncl_ncarg_src-5.2.1.tar.gz
2. tar -xvf ncl_ncarg_src-5.2.1.tar
3. setenv NCARG /usr/local/src/ncl_ncarg-5.2.1
4. cd $NCARG/config
make -f Makefile.ini
cc -O -c -o ymake-filter.o ymake-filter.c
cc -O -o ymake-filter ymake-filter.o./ymake -config 'pwd'
./ymake : Unable to open NCARG_CONFIG dir : pwd <<<<<< error message
Is there a problem ??
thank you
from Kbin
_______________________________________________
ncl-install mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-install
ncl-install mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-install
_______________________________________________
ncl-install mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-install
Received on Tue Dec 28 20:16:41 2010
This archive was generated by hypermail 2.1.8 : Tue Jan 04 2011 - 09:17:18 MST