Re: ncl in cygwin/X

[Tongli and I have been working on this offline.]

Usually when "ncl" just returns from the Cygwin prompt without any errors or action, this means that the version of Cygwin is old.

The V6.1.2 Cygwin binary was compiled under Cygwin 2.738. If "2.189" is indeed the Cygwin version that you have, then this is too old.

You need to download the latest "setup.exe" from http://x.cygwin.com/ and then run this new setup.exe to install a newer version of Cygwin.

--Mary

On Sep 3, 2013, at 4:07 PM, Wang, Tongli wrote:

> Hi there,
>
> I installed Cygwin/x (version: 2.189 (64-bit)) and ncl following the instruction at:
> http://www.ncl.ucar.edu/Download/cygwin.shtml
>
> Everything went through smoothly. However, when test ncl by
> ncl -V
> It does not show “6.1.2” as expected. It does not show any error message either. It simply came back to UNIX prompt.
>
> I reinstall the whole thing on a different directory, it ended up the same. I could not figure out what went wrong. Any help would be appreciated.
>
> Thanks,
> Tongli
> _______________________________________________
> ncl-install mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-install

_______________________________________________
ncl-install mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-install
Received on Wed Sep 4 09:16:11 2013