Re: ncl_filedump output

The attached which uses 5.1.1 was able to read/plot the data .. no problem.

Good luck

>The file is MOD021KM.A2000055.0000.005.2010041143816.hdf
>I am still using NCL 5.1.1 so that is probably why the unsigned
>integers are not supported.
>Since I am not in a rush to plot this data, would you recommend I wait
>for the full release of 5.2.0 or use the current beta? I notice on
>your website it says you hope to release 5.2.0 by the end of this >month.

>-Tong

On 04/06/2010 09:36 AM, Tong Qi wrote:
> Hello NCL-Talk,
>
> I am trying to plot some HDFEOS2 data, but after noticing that the
> output values did not correspond to the data, I used ncl_filedump and
> found that it was producing the wrong values as well. For example, the
> data I am trying to plot is a 2-D array of 16-bit unsigned integers, but
> ncl_filedump produces negative values that differ from the data. I am
> using HDFView to view the data. Any help is appreciated.
>
> Thanks,
> -Tong
>
>
>
> _______________________________________________
> ncl-talk mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-talk

-- 
======================================================
Dennis J. Shea                  tel: 303-497-1361    |
P.O. Box 3000                   fax: 303-497-1333    |
Climate Analysis Section                             |
Climate & Global Dynamics Div.                       |
National Center for Atmospheric Research             |
Boulder, CO  80307                                   |
USA                        email: shea 'at' ucar.edu |
======================================================

_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk