Re: hybrid sigma pressure

Correct ... D

On 05/18/2010 01:31 PM, Michael Notaro wrote:
> I made the attached plot of the difference in temperature between two CCSM3 simulations.
> The x axis is month. The y axis is hybrid sigma pressure coordinates. Temperature is
> averaged over the North American monsoon region, so it contains both high and low elevations.
>
> I just would like to verify that I don't need to mask any of the temperatures where the hybrid
> sigma pressure is> than the surface pressure (mountainous areas). My understanding
> is that the coordinate system is terrain following near the ground so this should be fine.
>
> Mike
>
>
>
>
> _______________________________________________
> ncl-talk mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-talk

-- 
======================================================
Dennis J. Shea                  tel: 303-497-1361    |
P.O. Box 3000                   fax: 303-497-1333    |
Climate Analysis Section                             |
Climate & Global Dynamics Div.                       |
National Center for Atmospheric Research             |
Boulder, CO  80307                                   |
USA                        email: shea 'at' ucar.edu |
======================================================
_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk