Re: Contouring temperature with GFS dataset.

I know Mary Haley requested that you send the output from a debug script.

Still, I looked at the script you sent. There were a number of resources
that were not set correctly. Variables such as 'i_lat_min' were not
defined, etc. I have attached a modified script. It ran just fine.

%> ncl v_file='"gfs.t18z.pgrb2f06.grb"' gfs_tempe.ncl

Good luck
D

On 06/07/2010 09:03 AM, Caroline Serraud wrote:
> Hello everyone,
>
> I am facing some trouble to plot contour of 2m-temperature from GFS data
> downloaded from NCEP FTP site (for example, gfs.t18z.pgrb2f06)
> NCL crashes when I run my script with default contour fill mode (area
> fill mode) but is ok with RasterFill mode.
>
> But with a 0,5° resolution I would really appreciate area mode because
> raster mode is not that pretty (see example attached)
> Did someone already experience plotting filled contour for
> 2m-temperature from GFS?
>
> Caroline
>
>
>
> _______________________________________________
> ncl-talk mailing list
> List instructions, subscriber options, unsubscribe:
> http://mailman.ucar.edu/mailman/listinfo/ncl-talk

-- 
======================================================
Dennis J. Shea                  tel: 303-497-1361    |
P.O. Box 3000                   fax: 303-497-1333    |
Climate Analysis Section                             |
Climate & Global Dynamics Div.                       |
National Center for Atmospheric Research             |
Boulder, CO  80307                                   |
USA                        email: shea 'at' ucar.edu |
======================================================

_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk