reading multiple ascii Tables and plotting

Dear all,

I am new in NCL. I have spent the past two weeks figuring out how to start making some plots. I have 26 ascii data files. I have attached three of them for an example. The 26 files are outputs at different times. I would like to plot them in a single plot each curve representing each file (time). Then I would like to plot selected times(datafiles) on a panel. I am attaching the ncl script I have written following some of the examples from the ncl-talk archive. I would like to make. The script works (if I chop the header off by hand - since I am unable to read it off) except that becuase I have concatenated the 26 files into one big file then the curves loops also because the x-axis of each starts at the same position.

Thanks in advance for any help and suggestions.

Regards,
Azwinndini

======================================================================
A/Professor - Department of Physics, Faculty of Science
University of Johannesburg, Auckland Park Kingsway Campus
cnr Kingsway Ave and University Rd
Building C1LAB, Room 235
Auckland Park 2092, RSA
PO Box 524, Auckland Park, 2006, RSA
Phone (UJ-APK-Office) : +27 11 559-3028
phone (UJ-APK-Sec) : +27 11 559-2327
fax (UJ-APK-Sec) : +27 11 559-2339
Director - UJ Soweto Science Centre, Faculty of Science
University of Johannesburg, Soweto Campus
Chris Hani Road, Pimville, Soweto
Phone (UJ Science Centre) : +27 11 559-5745
Fax (UJ Science Centre) : +27 11 559-5745
Skype : AzwinndiniMuronga
e-mail : Azwinndini.Muronga@gmail.com
e-mail : amuronga@uj.ac.za
======================================================================

________________________________

This email and all contents are subject to the following disclaimer:

http://disclaimer.uj.ac.za

_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk