According to the NCL website, fill patterns (hatching etc.) are only
partially supported when using ContourPlot:
http://www.ncl.ucar.edu/Document/Graphics/Resources/cn.shtml#cnFillMode
It says that fill patterns are supported when cnFillMode = AreaFill
(normal filled contour plots), but not for RasterFill or CellFill modes
(filled boxes).
Are there any plans to add fill pattern support for these other modes?
I would like to request that this support be added when feasible. I'm
constrained by a certain publication's black and white printing
requirements. Fill patterns within filled boxes would be the best
solution for my current problem. Thanks.
--Dave A.
CIRES Climate Diagnostics Center
NOAA Earth System Research Laboratory, Physical Sciences Division
_______________________________________________
ncl-talk mailing list
ncl-talk_at_ucar.edu
http://mailman.ucar.edu/mailman/listinfo/ncl-talk
Received on Thu Jun 08 2006 - 14:14:17 MDT
This archive was generated by hypermail 2.2.0 : Mon Jun 12 2006 - 06:59:42 MDT