Hello
I had been using NCL for reading and plotting WRF/Chem 3.4.1 files.
However, I recently switched to WRF/Chem 3.5 and successfully produced the
same files using the same namelist options. While I could see using tools
like ncview that the files are correct, NCL cannot read them.
I am getting segmentation fault in NCL. While the same files in WRF/Chem
3.4.1 are nicely being accessed by the same NCL.
Is this a bug?
-- Thanks & Regards Tabish Umar Ansari MS Research Scholar Environmental & Water Resources Engineering Division Department of Civil Engineering IIT Madras
_______________________________________________
ncl-talk mailing list
List instructions, subscriber options, unsubscribe:
http://mailman.ucar.edu/mailman/listinfo/ncl-talk
Received on Mon Feb 10 02:40:10 2014
This archive was generated by hypermail 2.1.8 : Wed Feb 12 2014 - 09:35:52 MST